Servicio

Home / Servicio / Transporte y almacenamiento

La superficie del panel ALUBANG está lacada, anodizada o laminada con una película de transformación. La superficie está protegida por una película durante el almacenamiento y el procesamiento del transporte. Debe tenerse en cuenta la siguiente información.

 

Desempaquetar y empacar

● Desembale y empaquete cajas de madera en un lugar limpio.

● Retire el polvo y las virutas del panel ALUBANG y del papel de embalaje. Las partículas duras, como arena y virutas cortantes, atrapadas entre los paneles causarán una abolladura en el panel.

● No manipule el panel ALUBANG en el piso, manipúlelo en una mesa de trabajo.

● Manipule el panel ALUBANG con cuidado por dos personas mirando hacia la superficie efectiva hacia arriba, para evitar posibles roces de la superficie del panel ALUBANG durante la recogida y el apilamiento de los paneles.

● Dos personas deben levantar los paneles individuales del palé y sostener las cuatro esquinas, y no deben colocarse uno sobre el otro. Llevar los paneles verticalmente. Usar guantes para evitar manchas.

 

 

Transporte

 

● Coloque el panel ALUBANG embalado horizontalmente y no coloque mercancías pesadas sobre él.

● Haga claramente "Manipular con cuidado", "mantener seco", "Sin ganchos" y "Este lado hacia arriba" en el embalaje.

● Trate las paletas con cuidado durante el transporte y los daños por humedad deben ser reportados inmediatamente y confirmados por el transportista.

● Trate las paletas con cuidado durante el transporte y los daños por humedad deben ser reportados inmediatamente y confirmados por el transportista.

 

 

Película protectora

It is possible that the protective film of ALUBANG panel will be invalid with direct sunlight and moisture.

● Especially in Reversible Series in which protective film are applied on both sides of the panel, make sure that each film is peeled off from front and back, although the film is translucent (half-transparent) and it may be slightly hard to notice it.

● Dirt deposits may build up in the course of the time where the protective film partly delaminated from the surface during handling.

● Storage exceeding 6 months should be avoided. Severe temperature fluctuations and exposure to direct sunlight reduce the long-term durability. In this case the protective film may become very difficult to remove.

● Do not mark the protective film with inks (markers), tapes or labels. Solvent or plasticizer may penetrate the film and affect the lacquered surface.

● Should the protective film partially come off during processing or after assembly, dirtied edges can occur in the course of time, which may be difficult to remove.

● Remove the protective film as soon as possible after assembly. Protective film that  remains on the panels for an extended period of exterior exposure may be very difficult to remove

 

 

Storage

 

● Store ALUBANG panel against rain and splash penetration of moisture, condensation. ALUBANG panel should always be stored in a cool, dry and temperature area. Don’t store them in moisture area.

● Pile the same size of panels on strong pallets. Do not pile up different sizes together. Stacks must not more than 6 pallets.

  • Si está expuesto a la humedad, deben secarse para evitar posibles manchas y corrosión. Cualquier recargo debe ser informado de inmediato y confirmado por el transportista

 

 

0